Aeon Labs DSC14014 Micro Motor Controller

From Wink@Home Wiki
Jump to: navigation, search
Aeon Labs DSC14014 Micro Motor Controller
EBay.jpg
Amazon.jpg
PRODUCT INFORMATION
Compatibility Unofficial - User Verified
Manufacturer Aeon Labs
Model/Part # DSC14014
Network Type ZWave
Category(s) Lights & Power
Type(s) Switch
Sub-Type(s) Other

PRODUCT FEATURES
Dimmable Xmark.png
Weatherproof Xmark.png
RGB Xmark.png
Tunable White Xmark.png
It Speaks Xmark.png
Touchscreen Xmark.png
Voice-Controlled Xmark.png

CONFIRMED WORKING: Unofficial - User Verified

Aeon Labs DSC14014 Micro Motor Controller


OVERVIEW


Micro motor controller is a Z-Wave motor driver specifically used to enable Z-Wave Command and control (open/close) for existing in-wall switches. The motor controller allows control of the motor via 2 wires and a neutral. The wireless module is powered from the mains Supply and is a three-wire design which requires a neutral connection. In the event of power failure, non-volatile memory retains all programmed information relating to the units operating status.

KEY FEATURES


  • Open/close control via Z-Wave, manual wall switch or built-in button
  • 3-wire installation
  • Small form factor that fit in most gang boxes worldwide
  • Z-wave certification Number: zc08-16010002

PRODUCT LINKS

DISCLAIMER

  1. Although I do my best to verify every product that is reported as compatible, things do change.
    • Firmware updates to either hub might render previously-compatible devices inoperable. Usually, problems like this are reported and addressed by Wink.
  2. Inclusion in this Wiki is a very good indicator of compatibility, but is not a guarantee.
    • One thing to be aware of is that "ZWave Plus" devices might not work with the Wink Hub (1st version), though they should work with the Wink Hub 2.
  3. I use a Wink Hub 2 as my primary controller.
    • My testing is done on the Wink Hub 2.
    • I try to find out if devices reported by others are Hub 1 or Hub 2, but I'm not always able to find out.
  4. I am a beta tester.
    • This means my hub might work with a device that won't work for the general public.
    • I try to avoid adding article for devices that are only compatible with the Wink beta firmware, but sometimes, something slips through.
    • If I report that it works, but it does not work for you, chances are it will start working for you in the near future.