Aeon Labs DSC19103-ZWUS Micro Illuminator/Dimmer, 2nd Edition

From Wink@Home Wiki
Jump to: navigation, search
Aeon Labs DSC19103-ZWUS Micro Smart Energy Illuminator G2
EBay.jpg
Amazon.jpg
PRODUCT INFORMATION
Compatibility Unofficial - User Verified
Manufacturer Aeon Labs
Model/Part # DSC19103-ZWUS
Network Type ZWave
Category(s) Lights & Power
Type(s) Dimmer
Sub-Type(s) Other

PRODUCT FEATURES
Dimmable Checkmark.png
Weatherproof Xmark.png
RGB Xmark.png
Tunable White Xmark.png
It Speaks Xmark.png
Touchscreen Xmark.png
Voice-Controlled Xmark.png

CONFIRMED WORKING: Unofficial - User Verified

Aeon Labs DSC19103-ZWUS Micro Smart Energy Illuminator G2


OVERVIEW


The Aeotec Micro Smart Energy Switch G2 is a low-cost Z-Wave appliance module specifically used to enable Z-Wave command and control onoff for existing in-wall switches. It can also report immediate wattage consumption or kWh energy usage over a period of time. The wireless module is powered from the mains supply and is a three-wire design which requires a neutral connection. In the event of power failure non-volatile memory retains all programmed information relating to the units operating status. It also is a repeater in the Z-Wave network. Acting as a bridge for communication it will forward Z-Wave command messages to their destinations if the originating controller is out of range from the destination node. By taking advantage of the Z-Wave mesh network commands can be routed to their destination via intermediary listening Z-Wave products. Products that are Z-Wave certified can be used and communicate with other Z-Wave certified devices. . For Use with HomeSeer and Other Z-Wave Automation Systems.

KEY FEATURES


  • Adds Z-Wave Wireless Control to Existing Conventional Wall Switches
  • Supports On - Off - Dim Control
  • For Use with HomeSeer and Other Z-Wave Automation Systems
  • Includes Energy Monitoring Features

NOTES

Power monitoring does not work with Wink at this time

PRODUCT LINKS

DISCLAIMER

  1. Although I do my best to verify every product that is reported as compatible, things do change.
    • Firmware updates to either hub might render previously-compatible devices inoperable. Usually, problems like this are reported and addressed by Wink.
  2. Inclusion in this Wiki is a very good indicator of compatibility, but is not a guarantee.
    • One thing to be aware of is that "ZWave Plus" devices might not work with the Wink Hub (1st version), though they should work with the Wink Hub 2.
  3. I use a Wink Hub 2 as my primary controller.
    • My testing is done on the Wink Hub 2.
    • I try to find out if devices reported by others are Hub 1 or Hub 2, but I'm not always able to find out.
  4. I am a beta tester.
    • This means my hub might work with a device that won't work for the general public.
    • I try to avoid adding article for devices that are only compatible with the Wink beta firmware, but sometimes, something slips through.
    • If I report that it works, but it does not work for you, chances are it will start working for you in the near future.