Aeon Labs ZW056 Z-Wave Plus Doorbell Gen5

From Wink@Home Wiki
Jump to: navigation, search
Aeon Labs ZW056 Z-Wave Plus Doorbell Gen5
EBay.jpg
Amazon.jpg
PRODUCT INFORMATION
Compatibility NO LONGER COMPATIBLE
Manufacturer Aeon Labs
Model/Part # ZW056
Network Type ZWave
Category(s) Access Control, Security & Monitoring
Type(s) Access Control
Security
Sub-Type(s) Doorbell
Siren

PRODUCT FEATURES
Dimmable Xmark.png
Weatherproof Xmark.png
RGB Xmark.png
Tunable White Xmark.png
It Speaks Xmark.png
Touchscreen Xmark.png
Voice-Controlled Xmark.png

ATTENTION: NO LONGER COMPATIBLE

Aeon Labs ZW056 Z-Wave Plus Doorbell Gen5



KEY FEATURES


  • Every press of Doorbell's outdoor button notifies your connected home that someone is at the door, allowing you to receive notifications, a chime in the home, and to activate any devices attached to your Z-Wave system.
  • Wirelessly communicating with Doorbell's button. Doorbell speaker offers configurable volume and tones and simply plugs into any power outlet. Each speaker module is only 64.8mm wide, 92.3mm high, and 30.8 deep.
  • Doorbell is easy to install. Its speaker simply plugs into a power outlet, and its button can be easily installed beside your front door with double-sided tape or small screws. * You'll find those easy installation methods provided in Doorbell's box, along with the USB cable that'll allow you change its alert tones.
  • From outside to in, Doorbell uses ultra-low powered wireless communication. There's no wiring necessary. Hear and see when someone is at your door via Doorbell's LED light alerts and customisable tones.

NOTES

This one is interesting. When you pair it to Wink, it shows up as a light switch. When the doorbell is pressed, the switch in Wink shows power on, when you release, the switch shows power off. Alternately, turning the "switch" on from within Wink will cause the doorbell chime to sound. This can be used as a sort of on-demand siren if needed.

PRODUCT LINKS

DISCLAIMER

  1. Although I do my best to verify every product that is reported as compatible, things do change.
    • Firmware updates to either hub might render previously-compatible devices inoperable. Usually, problems like this are reported and addressed by Wink.
  2. Inclusion in this Wiki is a very good indicator of compatibility, but is not a guarantee.
    • One thing to be aware of is that "ZWave Plus" devices might not work with the Wink Hub (1st version), though they should work with the Wink Hub 2.
  3. I use a Wink Hub 2 as my primary controller.
    • My testing is done on the Wink Hub 2.
    • I try to find out if devices reported by others are Hub 1 or Hub 2, but I'm not always able to find out.
  4. I am a beta tester.
    • This means my hub might work with a device that won't work for the general public.
    • I try to avoid adding article for devices that are only compatible with the Wink beta firmware, but sometimes, something slips through.
    • If I report that it works, but it does not work for you, chances are it will start working for you in the near future.