Dome DMOF1 Z-Wave On/Off Plug-In Switch with Energy Monitoring, Z-Wave Range Extender

From Wink@Home Wiki
Jump to: navigation, search
Dome DMOF1 Z-Wave On/Off Plug-In Switch with Energy Monitoring, Z-Wave Range Extender
Compatibility Officially Supported
Manufacturer Dome
Model/Part # DMOF1
Network Type ZWave
Category(s) Lights & Power
Type(s) Outlet
Sub-Type(s) Plugin

Dimmable Xmark.png
Weatherproof Xmark.png
RGB Xmark.png
Tunable White Xmark.png
It Speaks Xmark.png
Touchscreen Xmark.png
Voice-Controlled Xmark.png

Who Craig Trunzo
When 5/10/2017

CONFIRMED WORKING: Officially Supported

Dome DMOF1 Z-Wave On/Off Plug-In Switch with Energy Monitoring, Z-Wave Range Extender


The Dome Home Automation DMOF1 On/Off Plug is designed to give you control over small appliances from your smart device wherever you are. Conserve energy and save money always knowing how much power is used by every monitored appliance. Plug in your lamp and have it turn on/off on demand or according to preset schedule (Z-Wave Certified Hub required). Also great for humidifiers, dehumidifiers, air conditioners, space heaters, fans and holiday lights. It never blocks the other side of your duplex receptacle with the ergonomic design. Extra-long Z-Wave wireless range (up to 150 feet) allows you to place it where it’s needed without worrying if the signal is reaching your Z-Wave Hub. It also acts as a Z-Wave range extender. Dome DMOF1 On/Off Plug comes with a 1-year limited warranty. Measurements in inches: 1.625 by 1.625 by 2. The Dome Home Automation system gives your family peace of mind and security you can count on. With Dome, you’re always connected and always covered.


  • Used to turn On/Off lamps and small appliances for up to 13 Amps (1,560 Watts). Monitors energy consumption and shuts down device in case of overload
  • Ergonomic design allows it to only occupy single side of electrical duplex leaving the second outlet fully accessible
  • Up to 150-foot range. Operating Temperature: 32 degrees Farenheit to 112 degrees Farenheit
  • Z-Wave Plus Certified. Requires a Z-Wave Certified Hub to operate



  1. Although I do my best to verify every product that is reported as compatible, things do change.
    • Firmware updates to either hub might render previously-compatible devices inoperable. Usually, problems like this are reported and addressed by Wink.
  2. Inclusion in this Wiki is a very good indicator of compatibility, but is not a guarantee.
    • One thing to be aware of is that "ZWave Plus" devices might not work with the Wink Hub (1st version), though they should work with the Wink Hub 2.
  3. I use a Wink Hub 2 as my primary controller.
    • My testing is done on the Wink Hub 2.
    • I try to find out if devices reported by others are Hub 1 or Hub 2, but I'm not always able to find out.
  4. I am a beta tester.
    • This means my hub might work with a device that won't work for the general public.
    • I try to avoid adding article for devices that are only compatible with the Wink beta firmware, but sometimes, something slips through.
    • If I report that it works, but it does not work for you, chances are it will start working for you in the near future.