Dome DMWV1 Z-Wave Water Valve

From Wink@Home Wiki
Jump to: navigation, search
Dome DMWV1 Z-Wave Water Valve
EBay.jpg
Amazon.jpg
PRODUCT INFORMATION
Compatibility Officially Supported
Manufacturer Dome
Model/Part # DMWV1
Network Type ZWave
Category(s) HVAC
Type(s) Plumbing

PRODUCT FEATURES
Dimmable Xmark.png
Weatherproof Xmark.png
RGB Xmark.png
Tunable White Xmark.png
It Speaks Xmark.png
Touchscreen Xmark.png
Voice-Controlled Xmark.png

REPORTED BY
Who Craig Trunzo
When 6/27/2017

CONFIRMED WORKING: Officially Supported

Dome DMWV1 Z-Wave Water Valve


OVERVIEW


Now Officially Integrated with Wink! The Dome Home Automation DMWV1 Water Main Shut-off is designed to fit over existing 1/4 turn ball-valves for pipes sized up to 1 1/2 inch. No professional plumbing contractor is required -- it can be installed by a homeowner with just a screwdriver. This device requires a Z-Wave Certified hub for operation. When configured with a Water Leak Sensor, the Water Main Shut-off can automatically cut off the supply to limit the damage. You can also remotely control the valve position using your smarthome system mobile app. Extra-long Z-Wave wireless range (up to 150 feet) allows you to place it where it’s needed without worrying if the signal is reaching your Z-Wave Hub. This Water Main Shut-Off Valve also functions as Z-Wave signal extender. The Dome DMWV1 Water Main Shut-off Valve comes with a 1-year limited warranty. Measurements in inches: 2.5 by 3.5 by 6. Dome Home Automation Z-Wave devices give your family peace of mind and security you can count on. With Dome, you’re always connected and always covered.

KEY FEATURES


  • Installs over existing valve without need of a plumber using just a screw driver. Works with 1/4 turn ball-valves on pipes sized up to 1 1/2 inch
  • Open/Close valve control allowing for automatic water shut-off when leaks are detected as well as on demand control using your smarthome mobile app
  • Up to 150-foot range. Functions as Z-Wave signal extender
  • Z-Wave Plus Certified. Requires a Z-Wave Certified Hub to operate

PRODUCT LINKS

DISCLAIMER

  1. Although I do my best to verify every product that is reported as compatible, things do change.
    • Firmware updates to either hub might render previously-compatible devices inoperable. Usually, problems like this are reported and addressed by Wink.
  2. Inclusion in this Wiki is a very good indicator of compatibility, but is not a guarantee.
    • One thing to be aware of is that "ZWave Plus" devices might not work with the Wink Hub (1st version), though they should work with the Wink Hub 2.
  3. I use a Wink Hub 2 as my primary controller.
    • My testing is done on the Wink Hub 2.
    • I try to find out if devices reported by others are Hub 1 or Hub 2, but I'm not always able to find out.
  4. I am a beta tester.
    • This means my hub might work with a device that won't work for the general public.
    • I try to avoid adding article for devices that are only compatible with the Wink beta firmware, but sometimes, something slips through.
    • If I report that it works, but it does not work for you, chances are it will start working for you in the near future.