Enerwave ZWN-RSM1S Z-Wave Smart Single Relay Switch Module with Bypass Function

From Wink@Home Wiki
Jump to: navigation, search
Enerwave ZWN-RSM1S Z-Wave Smart Single Relay Switch Module with Bypass Function
EBay.jpg
Amazon.jpg
PRODUCT INFORMATION
Compatibility Officially Supported
Manufacturer Enerwave
Model/Part # ZWN-RSM1S
Network Type ZWave
Category(s) Lights & Power
Type(s) Switch
Sub-Type(s) Other
Files ZWN-RSM1S.pdf

PRODUCT FEATURES
Dimmable Xmark.png
Weatherproof Xmark.png
RGB Xmark.png
Tunable White Xmark.png
It Speaks Xmark.png
Touchscreen Xmark.png
Voice-Controlled Xmark.png

CONFIRMED WORKING: Officially Supported

Enerwave ZWN-RSM1S Z-Wave Smart Single Relay Switch Module with Bypass Function


OVERVIEW


Z-Wave unifies all your home electronics into an integrated wireless network and helps them talk to each other. Any Z-Wave enabled item can be added to the network, and making your home electronics fully compatible. The ZWN-RSM1S Switch Module is a component of lighting control system, it can not be used separately but should turn an existing switch into a Z-Wave switch. This ZWN-RSM1S module is a Z-Wave enabled device and is fully compatible with any Z-Wave enabled network. In a Z-Wave network, each device is designed to act as a wireless repeater. Once the ZWN-RSM1S module is installed and setup with in your wall, it will retransmit the RF signal from one device to another until the intended device is reached. This ensures that the signal is received by its intended destination by routing the signal around obstacles and radio dead spots.

KEY FEATURES


  • Upgrates existing wall switch into a Z-Wave switch so you can still keep the original switch and wall plate
  • Wireless ON/OFF switch control on light, fans or other load from smart phone, tablet or desktop apps
  • ON/OFF control of connected load can be programmed into z-wave scenes, schedule and events from anywhere
  • Acts as a Z-Wave repeater to extend the range; The switch still works if the module is failed
  • NEUTRAL WIRE required; Single Pole; 120-277 VAC, 50/60Hz; Up to 100 feet distance;2yr warrenty

NOTES

Modules installed behind switch in a single gang electrical box

PRODUCT LINKS

DISCLAIMER

  1. Although I do my best to verify every product that is reported as compatible, things do change.
    • Firmware updates to either hub might render previously-compatible devices inoperable. Usually, problems like this are reported and addressed by Wink.
  2. Inclusion in this Wiki is a very good indicator of compatibility, but is not a guarantee.
    • One thing to be aware of is that "ZWave Plus" devices might not work with the Wink Hub (1st version), though they should work with the Wink Hub 2.
  3. I use a Wink Hub 2 as my primary controller.
    • My testing is done on the Wink Hub 2.
    • I try to find out if devices reported by others are Hub 1 or Hub 2, but I'm not always able to find out.
  4. I am a beta tester.
    • This means my hub might work with a device that won't work for the general public.
    • I try to avoid adding article for devices that are only compatible with the Wink beta firmware, but sometimes, something slips through.
    • If I report that it works, but it does not work for you, chances are it will start working for you in the near future.