Enerwave ZWN-RSM2 Z-Wave Smart Dual Relay Switch Module Control 2 Loads

From Wink@Home Wiki
Jump to: navigation, search
Enerwave ZWN-RSM2 Z-Wave Smart Dual Relay Switch Module Control 2 Loads
Compatibility Unofficial - User Verified
Manufacturer Enerwave
Model/Part # ZWN-RSM2
Network Type ZWave
Category(s) Lights & Power
Type(s) Switch
Sub-Type(s) Other
Files ZWN-RSM2.pdf

Dimmable Xmark.png
Weatherproof Xmark.png
RGB Xmark.png
Tunable White Xmark.png
It Speaks Xmark.png
Touchscreen Xmark.png
Voice-Controlled Xmark.png

CONFIRMED WORKING: Unofficial - User Verified

Enerwave ZWN-RSM2 Z-Wave Smart Dual Relay Switch Module Control 2 Loads


  • Single power source can control 2 outputs independently.
  • Can use existing "dumb" switches to add zwave functionality to your current setup.
  • Displays as 2 separate switches when paired with Wink.


  • To pair with Wink
    1. Go into your Hub screen
    2. Click the 3-dot menu and choose your hub
    3. Go into the "Z-Wave Controls" section. DO NOT HIT "RESET ZWAVE"
    4. Tap "Inclusion Mode"
    5. Follow the instructions that came with the Everwave to pair it.
  • The device is going to add 3 devices into your "Lights + Power" section. There are only 2 switches, but for some reason, one of them gets duplicated. Just rename it so you know it's the duplicate and rearrange it to the bottom of your device list.

Wiring Diagrams

Wiring Diagram to connect two existing switches Wiring Diagram to create dual controllable outlet



  1. Although I do my best to verify every product that is reported as compatible, things do change.
    • Firmware updates to either hub might render previously-compatible devices inoperable. Usually, problems like this are reported and addressed by Wink.
  2. Inclusion in this Wiki is a very good indicator of compatibility, but is not a guarantee.
    • One thing to be aware of is that "ZWave Plus" devices might not work with the Wink Hub (1st version), though they should work with the Wink Hub 2.
  3. I use a Wink Hub 2 as my primary controller.
    • My testing is done on the Wink Hub 2.
    • I try to find out if devices reported by others are Hub 1 or Hub 2, but I'm not always able to find out.
  4. I am a beta tester.
    • This means my hub might work with a device that won't work for the general public.
    • I try to avoid adding article for devices that are only compatible with the Wink beta firmware, but sometimes, something slips through.
    • If I report that it works, but it does not work for you, chances are it will start working for you in the near future.