HomeSeer HS-WA100 Wired 3-Way Companion Switch

From Wink@Home Wiki
Jump to: navigation, search
HomeSeer HS-WA100 Wired 3-Way Companion Switch
EBay.jpg
Amazon.jpg
PRODUCT INFORMATION
Compatibility Unofficial - User Verified
Manufacturer HomeSeer
Model/Part # HS-WA100
Network Type ZWave
Category(s) Lights & Power
Type(s) Dimmer
Sub-Type(s) Hardwired

PRODUCT FEATURES
Dimmable Checkmark.png
Weatherproof Xmark.png
RGB Xmark.png
Tunable White Xmark.png
It Speaks Xmark.png
Touchscreen Xmark.png
Voice-Controlled Xmark.png

CONFIRMED WORKING: Unofficial - User Verified

HomeSeer HS-WA100 Wired 3-Way Companion Switch


OVERVIEW


HS-WA100+ is a wired (non-RF) 3-way wall companion switch that provides remote control of HomeSeer load controlling wall switches (HS-WS100+, HS-WD100+). HS-WA100+ is designed to be wired directly to the HS-WS100+ or HS-WD100+ using a "traveler" wire. Note: THIS SWITCH CANNOT BE USED BY ITSELF TO CONTROL A LOAD! It can only be used with HomeSeer HS-WD100+ and HS-WS100+ Z-Wave wall dimmers and switches.

KEY FEATURES


  • Wired (non-RF) 3-way companion switch that MUST BE USED with HomeSeer HS-WS100+ and HS-WD100+ wall switches
  • Can remotely activate double-tap, triple-tap and press & hold functions for connected HS-WD100+ and HS-WS100+ switches - Requires HomeSeer home automation system
  • Installation requires neutral and traveler wires
  • Easy screw terminal installation

NOTES

Use as a companion switch to create a 3-way circuit with HomeSeer HS-WD100 Z-Wave Plus Wall_Dimmer and HomeSeer HS-WS100 Z-Wave Plus Wall Switch

PRODUCT LINKS

DISCLAIMER

  1. Although I do my best to verify every product that is reported as compatible, things do change.
    • Firmware updates to either hub might render previously-compatible devices inoperable. Usually, problems like this are reported and addressed by Wink.
  2. Inclusion in this Wiki is a very good indicator of compatibility, but is not a guarantee.
    • One thing to be aware of is that "ZWave Plus" devices might not work with the Wink Hub (1st version), though they should work with the Wink Hub 2.
  3. I use a Wink Hub 2 as my primary controller.
    • My testing is done on the Wink Hub 2.
    • I try to find out if devices reported by others are Hub 1 or Hub 2, but I'm not always able to find out.
  4. I am a beta tester.
    • This means my hub might work with a device that won't work for the general public.
    • I try to avoid adding article for devices that are only compatible with the Wink beta firmware, but sometimes, something slips through.
    • If I report that it works, but it does not work for you, chances are it will start working for you in the near future.