NYCE NCZ-3010 Door Hinge Sensor

From Wink@Home Wiki
Jump to: navigation, search
NYCE NCZ-3010 Door Hinge Sensor
Compatibility Unofficial - User Verified
Manufacturer NYCE
Model/Part # NCZ-3010
Network Type Zigbee
Category(s) Access Control, Security & Monitoring
Type(s) Monitoring
Sub-Type(s) Open/Close

Dimmable Xmark.png
Weatherproof Xmark.png
RGB Xmark.png
Tunable White Xmark.png
It Speaks Xmark.png
Touchscreen Xmark.png
Voice-Controlled Xmark.png

Who Craig Trunzo
When 6/27/2017

CONFIRMED WORKING: Unofficial - User Verified

NYCE NCZ-3010 Door Hinge Sensor


NYCE’s wireless Door Hinge Sensor combines the features of a Door Sensor and ZigBee (802.15.4) radio into a single standard ANSI hinge device. Packed with intelligent features, the Door Hinge Sensor expands your network’s possibilities – monitoring any type of door anywhere in the home – and all without any wires.

For more information and product manuals visit:

Included in the box: 1. The hinge with ZigBee module attached. 2. A pack of 4 installation screws. 3. A pack of 2 set screws (Short & Long) with Hex key.


  • Long Battery Life (up to 5 years), Three color LED event indication
  • Easy 5 Minute Retrofit install (no magnet)
  • Reports Open/Closed Status of Doors
  • User a 2032 button battery.


These come in 4 varieties. All of them have 5/8" rounded corners

  • 3.5" Satin Nickle (NCZ-3010-1-HA)
  • 4" Satin Nickle (NCZ-3010-2-HA)
  • 3.5" Oil-Rubbed Bronze (NCZ-3010-3-HA)
  • 4" Oil-Rubbed Bronze (NCZ-3010-4-HA)

PLEASE MAKE SURE YOU GET THE VERSION WITH "HA" AT THE END. The parts without "HA" are for a different security system and are not zwave compatible.



  1. Although I do my best to verify every product that is reported as compatible, things do change.
    • Firmware updates to either hub might render previously-compatible devices inoperable. Usually, problems like this are reported and addressed by Wink.
  2. Inclusion in this Wiki is a very good indicator of compatibility, but is not a guarantee.
    • One thing to be aware of is that "ZWave Plus" devices might not work with the Wink Hub (1st version), though they should work with the Wink Hub 2.
  3. I use a Wink Hub 2 as my primary controller.
    • My testing is done on the Wink Hub 2.
    • I try to find out if devices reported by others are Hub 1 or Hub 2, but I'm not always able to find out.
  4. I am a beta tester.
    • This means my hub might work with a device that won't work for the general public.
    • I try to avoid adding article for devices that are only compatible with the Wink beta firmware, but sometimes, something slips through.
    • If I report that it works, but it does not work for you, chances are it will start working for you in the near future.