Somfy ZRTSI RTS 16 Channel Z-Wave to RTS Plug-in Interface Wall Module

From Wink@Home Wiki
Jump to: navigation, search
Somfy ZRTSI RTS 16 Channel Z-Wave to RTS Plug-in Interface Wall Module
Compatibility Officially Supported
Manufacturer Somfy
Model/Part # ZRTSI
Network Type ZWave
Category(s) Other Stuff
Type(s) Shades

Dimmable Xmark.png
Weatherproof Xmark.png
RGB Xmark.png
Tunable White Xmark.png
It Speaks Xmark.png
Touchscreen Xmark.png
Voice-Controlled Xmark.png

CONFIRMED WORKING: Officially Supported

Somfy ZRTSI RTS 16 Channel Z-Wave to RTS Plug-in Interface Wall Module


Control your Somfy devices with Z-Wave controllers! Simply connect the Somfy Z-Wave to RTS Interface to your Somfy TaHomA home automation system. The Interface will receive commands from your Z-Wave controller, and then convert them into Radio Technology Somfy (RTS) commands for up to 16 connected RTS motors or groups of motors. Integrating RTS devices into the Somfy Z-Wave to RTS Interface is easy through intuitive digital menus, displayed clearly on an LCD screen. The Interface has one base node and 16 virtual nodes. The virtual nodes correspond to 16 RTS channels. Once programmed into the Interface, these virtual nodes duplicate all settings for each channel within the Z-Wave network. The Interface requires 110VAC power and can be plugged into any standard outlet. NOTE: One Somfy Z-Wave to RTS Interface is recommended for each 25 to 35-foot area where RTS motors are present.


  • Enables Z-Wave control for RTS motors
  • Supports up to 16 groups of RTS devices
  • Plugs into a standard power outlet


[Per Michael Riksman]

For those on 240V, this can be converted by swapping out the 120VAC to 6AC encapsulated transformer with a pin compatible 240VAC variety you'll also need to swap the protection Varistor (VAR1) with a 400V one. Easy to do.



  1. Although I do my best to verify every product that is reported as compatible, things do change.
    • Firmware updates to either hub might render previously-compatible devices inoperable. Usually, problems like this are reported and addressed by Wink.
  2. Inclusion in this Wiki is a very good indicator of compatibility, but is not a guarantee.
    • One thing to be aware of is that "ZWave Plus" devices might not work with the Wink Hub (1st version), though they should work with the Wink Hub 2.
  3. I use a Wink Hub 2 as my primary controller.
    • My testing is done on the Wink Hub 2.
    • I try to find out if devices reported by others are Hub 1 or Hub 2, but I'm not always able to find out.
  4. I am a beta tester.
    • This means my hub might work with a device that won't work for the general public.
    • I try to avoid adding article for devices that are only compatible with the Wink beta firmware, but sometimes, something slips through.
    • If I report that it works, but it does not work for you, chances are it will start working for you in the near future.