ZWave Products WD-100 Z-Wave Multi-Level Dimmer Switch
CONFIRMED WORKING: Unofficial - User Verified
Dragon Tech WD-100 Z-Wave Multi-Level Dimmer Switch
Used with Dragon Tech WA-100 3-way Auxiliary switch to create a 3-way circuit. A traveler wire IS required.
USER NOTES (Thanks Paul Ferrara)
- Overall good build quality and solid feel, I like the physical switch and LEDs to show dimming
- Nice packaging and documentation
- Paired with wink by using z wave inclusion mode
- Exclusion was successful as well
- Slow to react - 5-7 seconds from command issue to switch acting
- Changes in dimming are made abruptly -- the connected lamp does not smoothly fade between dimming levels
- Dimmer and bulbs buzz very badly when dimmed. This makes the unit almost useable in its present location. I am currently running 4x cree "4-flow" a19 equivalent bulbs that draw 11w watts each. I tried with a single osram 9w a19 equivalent and the buzz was not as bad, but still very noticeable.
- Although I do my best to verify every product that is reported as compatible, things do change.
- Firmware updates to either hub might render previously-compatible devices inoperable. Usually, problems like this are reported and addressed by Wink.
- Inclusion in this Wiki is a very good indicator of compatibility, but is not a guarantee.
- One thing to be aware of is that "ZWave Plus" devices might not work with the Wink Hub (1st version), though they should work with the Wink Hub 2.
- I use a Wink Hub 2 as my primary controller.
- My testing is done on the Wink Hub 2.
- I try to find out if devices reported by others are Hub 1 or Hub 2, but I'm not always able to find out.
- I am a beta tester.
- This means my hub might work with a device that won't work for the general public.
- I try to avoid adding article for devices that are only compatible with the Wink beta firmware, but sometimes, something slips through.
- If I report that it works, but it does not work for you, chances are it will start working for you in the near future.